![]() Thanks in advance for any suggestions to get the VGA-to_HDMI adapter work with Windows 10. I was only switching KB+Mouse and using different monitor ports for different machines.Īs I said before, this all (including vga-to-hdmi adapter) works perfectly on Mint 20.2 - a Ubuntu 20.2 derivative that "Just Works". Removed HDMI cable from display - waited 10 seconds and plugged HDMI back in and it did not help - this usually works when HDMI EDID detection hangs.Īll this works fine with no adapter, just VGA cable and manually changing input on secondary monitor.Īnyway, my new dual monitor KVM switch works perfectly but this problem kinda defeats the KVM purpose. Tried "Multiple Displays" setup and performed identify - no display on that channel. Secondary display does not show up in Device Manager. Windows 10 is up to date with all patches. The secondary display shows up blank - it does flash a little HDMI pop-up from the monitor detecting mode change then shuts down as if no signal. I assumed Windows would work but just re-booted into Windows 10. It runs perfectly with Mint 20.2 out of the box. I only have to plug the VGA male adapter, the USB connector, the audio jack, and the HDMI on the opposite side. The device matches my old computer and a high-end projector. I picked the Vention adapter since it had the Amazon's Choice for "vga to hdmi" tag on it. I love the FOINNEX VGA to HDMI Adapter for the convenience it brings. ![]() The adapter converts an aging HP laptop secondary display (vga) to HDMI so I do not have to switch my monitor back and forth.
0 Comments
Leave a Reply. |